Jump to content
Thai Visa Forum

3/4G Modem. router and AT commands


Recommended Posts

I'm trying to use a Huawei E3276S dongle with a GL-MT300N V2 router.  The connection to the network was straightforward enough and it's working well.

 

What I'm trying to do is work out how to send USSD codes through the router interface to check balance and buy one off internet packages.

 

The limited research I've done suggests AT+CUSD=1, "#123",15 should work but it errors out  with +CM# ERROR: UNKOWN

 

Any ideas or suggestions of another way to do what I want with swapping the SIM between the dongle and a phone?

 

Thanks

 

 

 

 

Edited by Jai Dee
Font resized
Link to post
Share on other sites

 

Seems dongle/SIM connects to True mobile?

You want to send "#123"?

Isn't it "#123#"?

Edited by KhunBENQ
Link to post
Share on other sites

is there an extra space between

1,

and

"#123

?

 

try the test command (show phone number):

AT+CUSD=1,"99",15

 

 

Link to post
Share on other sites
Posted (edited)
9 minutes ago, KhunBENQ said:

 

Seems dongle/SIM connects to True mobile?

You want to send "#123"?

Isn't it "#123#"?

Yes  I'm trying to use True.

 

That was just a typo on here.  I was sending the correct code when I tried. 

Edited by JaiMaai
typo (ironically enough)
Link to post
Share on other sites
6 minutes ago, fdsa said:

is there an extra space between

1,

and

"#123

?

 

try the test command (show phone number):

AT+CUSD=1,"99",15

 

 

Sending that command returns "OK" without anything else.

Link to post
Share on other sites
5 minutes ago, JaiMaai said:

Sending that command returns "OK" without anything else.

wait for several seconds, OK is a confirmation of receiving the command and after few seconds it shows the phone number.

 

# socat - /dev/ttyUSB2,b115200,crnl
AT

OK
AT+CUSD=1,"99",15

OK

+CUSD: 0,"MSISDN:66952012345",15   <<<===  shown after few seconds

AT+CUSD=1,"#123",15

OK   <<<<==== and nothing else happens 
AT

OK
AT+CUSD=1,"#123#",15    <<<=== note the second # after 123

OK

+CUSD: 0,"TrueMove-H credit is 16.79 Bt, you can use service until 26/10/2021",15  <<<=== shown after a few seconds

 

 

Link to post
Share on other sites

I think part of the problem may be that the router interface is not a fully-fledged terminal and just allows basic input.

 

I'll try and find a way of sending the commands another way,

A.jpg

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...